Hello everyone,
Here is the very good method for watching DishTV free, only for FTA (Free to Air) channels, DD direct + and Dish TV shares some tp (transponder) of INSAT- 4B. According to TRAI all DTH has to give DD+ Channel free in there service but they don't follow these rules.........
Presently, DishTV is using CONAX encryption (CAS7) this trick does not matter which encryption STB is using...!!.
How does it work ??
Here is the very good method for watching DishTV free, only for FTA (Free to Air) channels, DD direct + and Dish TV shares some tp (transponder) of INSAT- 4B. According to TRAI all DTH has to give DD+ Channel free in there service but they don't follow these rules.........
Presently, DishTV is using CONAX encryption (CAS7) this trick does not matter which encryption STB is using...!!.
How does it work ??
@
First,supply ON the power of
STB and set the channel to be
view than short the chip (RAM)
with screw driver or any conducting
metal, pin's at @ (pic.)
It will hang the processing of SET OF BOX further. You can't change anything from your Remote and STB
itself...!!
Due to undesirable addressing
occurred by shorting chip it will hang STB working (only the external device like remote and push on/off switches of STB).
Repeat, This process again and
again for viewing other
channel.
DishTV satellite
NSS 6 at 95.0°E
NSS 6 at 95.0°E
DishTV HD satellite
AsiaSat 5 at 100.5°E
AsiaSat 5 at 100.5°E
4 Banks x 2M x 16bits Synchronous DRAM
@
After so many request form viewer's, How to setup Satellite reception. here i will tell all basic step.
For a new guy in this field..............!!
1. First find your local latitude and longitude.
2. Buy a cheap magnetic needle, easily available in market.
set 0* degree to north then rotate dish.
3. How much to rotate and elevate Dish:-
There are many method like check online or in
STB itself.
Set LNB ku band frequency at 9750 or 10600 Mhz
( low ku band and hi ku band frequency )
4. This is the main setup, fix your dish at solid place
beware that there should not be any obstacle
between satellite and dish.
5. Last step, add all frequency details in STB and adjust
dish to receive maximum signal strength.
If signal remain weak then rotates your LNB
( feed horn) this is also called skew angle .
For a new guy in this field..............!!
1. First find your local latitude and longitude.
2. Buy a cheap magnetic needle, easily available in market.
set 0* degree to north then rotate dish.
3. How much to rotate and elevate Dish:-
There are many method like check online or in
STB itself.
Set LNB ku band frequency at 9750 or 10600 Mhz
( low ku band and hi ku band frequency )
4. This is the main setup, fix your dish at solid place
beware that there should not be any obstacle
between satellite and dish.
5. Last step, add all frequency details in STB and adjust
dish to receive maximum signal strength.
If signal remain weak then rotates your LNB
( feed horn) this is also called skew angle .
Note :- It work only for FTA provided by DD Direct+ !!
 |
Create A Free Website With WebStarts.com |
